The DGE-530T is a 10/100/1000Mbps copper Gigabit PCI card for desktop PC. Installable in a PC equipped with PCI expansion slots, this card turns a desktop computer into a high-bandwidth Gigabit workstation or a server running at 2000Mbps full-duplex speed. Capable of running at full-duplex Gigabit speed, this card gives your PC 2000Mbps data transmission on your existing Cat. 5 twisted-pair network cable. As an inexpensive alternative solution to fiber-optic, the card allows you to instantly upgrade to Gigabit without requiring you to install new, expensive fiber cables. The card supports 10/100/1000Mbps network speed auto-sensing and full/half duplex auto-negotiation. The card provides on-board screening of VLANs Tagged Ethernet frames, allowing your PC to be configured with a VLAN-supported switch. Your PC can be part of a VLAN network, where domains are segmented up to enhance performance and security. The card's embedded flow control and independent FIFO for each port provide a means to protect against possible data loss during transmission on the network. When connected to a Gigabit switch Supporting flow control, the card receives signals from the switch regarding buffer overrun during peak usage periods. The card then delays transmission until the switch is ready again to accept new data. Using a single chip solution, this card is very small in size and consumes very little power of your computer system.

Features:

• Product Description: D-Link DGE 530T - network adapter
• Device Type: Network adapter
• Form Factor: Plug-in card
• Interface (Bus) Type: PCI low profile
• Cabling Type: Ethernet 10Base-T, Ethernet 100Base-TX, Ethernet 1000Base-T
• Data Link Protocol Ethernet, Fast Ethernet, Gigabit Ethernet
• Data Transfer Rate: 1 Gbps
• Compliant Standards: IEEE 802.3, IEEE 802.3U, IEEE 802.1Q, IEEE 802.3ab, IEEE 802.1p, IEEE 802.3x
• System Requirements: Novell NetWare 4.2, Novell NetWare 5.x, Microsoft Windows NT, Novell NetWare 6.x, Microsoft Windows 98 Second Edition / Windows ME, Microsoft Windows 2000 / XP, Red Hat Linux 7.3 or later